Decorated Easter Egg with Bow

Decorated Easter Egg with Bow
 
Recommended Print Settings Layer Height: 0.12–0.20 mm
Walls: 2–3 perimeters
Infill: 10–20%
Material: PLA, PETG, or resin
Supports: Use supports in the critical areas only — the model is designed so that only a few small zones need support depending on your slicer and orientation.
Thread & Image Alignment To ensure the artwork lines up when the egg is fully closed, start the screw connection at a 90‑degree orientation (as shown in the reference image).If the design doesn’t align when tightened, simply back it off and begin threading from the next starting point.
Thread Break‑In Tip For the first couple of turns, walk the threads back and forth gently before tightening fully. This helps clear any tiny print artifacts and ensures the halves seat smoothly.