Stonehands Cellphone Holder
Forged from the same imaginary bedrock that anchors our titans and guardians, the Stonehands Cellphone Holder is a functional sculptural piece designed to feel like it was carved straight out of a forgotten cliffside temple. Massive palms rise from a fractured base, fingers curling just enough to cradle your phone in either orientation—no clips, no gimmicks, just raw, monolithic presence.
Absolutely — here’s a clean, member‑friendly Print Settings block you can drop right into your release notes. It keeps things simple, practical, and tuned for both high‑speed machines and standard printers.
Recommended Print Settings
Optimized for a fully support‑free print.High‑Speed Printers (Bambu, K1, P1S, X1C, etc.)
- Layer Height: 0.20–0.28 mm
- Nozzle Temp: As per filament (usually 215–225C PLA)
- Bed Temp: 55–60C
- Walls: 3
- Top/Bottom: 4–5 layers
- Infill: 10–15% (Gyroid or Cubic)
- Cooling: 100% after first few layers
- Speed: 200–300 mm/s (or your machine’s “Sport/Turbo” preset)
- Flow Calibration: Recommended for best stone‑texture fidelity
- Brim: Optional (5–8 mm if your plate adhesion is weak)
Notes:
The rocky geometry hides layer lines beautifully, so high‑speed mode still looks premium. No supports needed anywhere.
Regular Printers (Ender 3, Prusa MK3/MK4, Anycubic, etc.)
- Layer Height: 0.20 mm
- Nozzle Temp: 205–215C PLA
- Bed Temp: 55–60C
- Walls: 3
- Top/Bottom: 4–5 layers
- Infill: 12–15%
- Cooling: 100% after layer 3
- Speed: 50–70 mm/s
- Brim: Optional but helpful for smaller beds
- Z‑Hop: On (0.2–0.4 mm) to avoid knocking the fingertips
Notes:
Prints cleanly on even modest machines thanks to the angled geometry and natural overhangs.
Whether you’re charging, watching, displaying, or just flexing your desk aesthetic, this piece brings that signature Mesh Mayhem blend of utility and mythic style.
